Looking for a working 88 shelby z cluster. Needs to be 1988 only. Car is wired for a 88 cluster. Paypal money ready to go
Looking for a working 88 shelby z cluster. Needs to be 1988 only. Car is wired for a 88 cluster. Paypal money ready to go
i have a 70 k working one at my part storage . could meet you along 78 somewere 50 bucks thanks
I dont have any time or id pick the one up that came out of the car from the guy as hes in Easton. Its more expensive driving than paying shipping
i ship prob like 15 for usps
i have it here . been stored inside my house from 2001 . miles 70868 on the od
Its definately 1988? Cause if its anything else im soo beat. Any part numbers on it?
4375145 07902 on back board
I thought '87-'89 were the same?
Im comparing the instrument pin diagrams to try to figure that out. theres gotta be slight differences because the 89 cluster i put in the car the check engine light doesnt blink to pull codes, the gas gauge needle counts it. the coolant temp sensor is not working, if the headlights are on the whole cluster goes haywire and the gauges go nuts all the way to their max points
Last edited by Xtrempickup; 12-02-2014 at 09:08 AM.
Wild. I know I tried a couple '87 clusters in my '88; I don't know if I tried any '89s for sure or not.
Yea the 90 TC cluster that must be a little diff the 89 does similar things bit neither gives me the check engine light codes which im trying to get to figure out whats up with my set up. Im hoping its something stupid like the clusters just are slightly different but according the diagrams i cant seem to see anything that standards out. I gotta check the part number on the boards today to see if they are different or the same number. With the lights off, almost all the gauges work but the temp gauge and check engine. Either its staying lit from start on or the cluster is lighting up the wrong spot because the pins are different and its really supposed to be the brake light cause those arent quite right yet. Im trying to not have to rewire this car because before it was parted, that all worked, I drove the car when it was for sale whole with the cluster that was in it that the owner has still of i wna drive to Easton pa to pick up
well let me know when you make up your mind . should be like 65. shipped if you pm your address i will check thanks .
Ok so the part number is the same 87-89 on the circuit boards. Im gonna have to grab the original cluster off the previous owner.