Is there a way to tell which springs I have on the Omni from wire diameter and coil count??
Is there a way to tell which springs I have on the Omni from wire diameter and coil count??
Crap
I have the diameters written down somewhere
I remember the front MP lowering springs were like ,020-.030" bigger than stock, it isn't much
I bought a full set of MP springs from a guy and measured the rears and could not tell a difference
in the diameter vs. stock
Not sure if I got ripped off or maybe they are just harder
Same here, I wrote some coil diameters down when I replaced mine. I think I have had factory, MP and LRE springs on my l-bodies. Okay I found a portion of what I was looking for. Factory front non-AC springs were .578 wire diameter, and MP autocross were .624. I'll keep looking,
Todd
Alright the ones on the front of the Omni measure .624 and the back measure .440 thanks for the info
LRE backs are .472 and are progressive. I will check fronts tomorrow.
Thanks for checking them
Anyone ever get some specs for the front lre springs
I got around .670 for LRE fronts.