Results 1 to 2 of 2

Thread: Steel floor pan plugs

  1. #1
    Supporting Member Turbo Mopar Contributor supercrackerbox's Avatar
    Join Date
    Dec 2005
    Location
    Firth, Nebraska
    Posts
    5,022

    Steel floor pan plugs

    Does anyone know a source for those steel plugs that have the tabs you push down to lock in place and then pack full of body sealer? The ones in the inside rear quarter of my GLHS have rotted to nothingness.

    I was wondering how the heck the RR quarter panel got all that mud on the inside . . .

  2. #2
    Super Moderator Turbo Mopar Staff 135sohc's Avatar
    Join Date
    Aug 2008
    Location
    SoMd
    Posts
    6,178

    Re: Steel floor pan plugs

    I used a piece of sheet steel cut to size and a couple pop rivets. Everything went together wet with JB weld and lots of undercoating on the outside after the epoxy setup. The repairs I did a few years ago on the Shadow are holding up very well.

Similar Threads

  1. General WTB Floor Shifter Bracket Section of Floor
    By trbowgn in forum Parts Wanted
    Replies: 1
    Last Post: 04-18-2013, 09:52 PM
  2. Stainless steel for floor replacement?
    By Nemesismachine in forum Interior & Exterior Restoration
    Replies: 2
    Last Post: 06-22-2011, 09:44 AM
  3. L-Body floor plugs.
    By rx2mazda in forum Interior & Exterior Restoration
    Replies: 1
    Last Post: 12-26-2010, 01:35 PM
  4. Steel core plugs
    By 1BADVAN in forum 16v Factory Engines
    Replies: 22
    Last Post: 06-13-2010, 12:37 AM
  5. steel plugs
    By shellboy in forum 16v Factory Engines
    Replies: 6
    Last Post: 06-12-2008, 07:27 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •