I have a couple of bcm's from 92+ lebaron and Daytona. I need to replace the relays in both of them, made a stupid mistake.. Anyways, where do I find 4 of these board mounted relays?
Anyone ever rebuilt a bcm?
I have a couple of bcm's from 92+ lebaron and Daytona. I need to replace the relays in both of them, made a stupid mistake.. Anyways, where do I find 4 of these board mounted relays?
Anyone ever rebuilt a bcm?
I'd start with a Google search for the part number shown on the relay itself, being a soldered type, I don't think we'll have a vendor that stocks them, more likely an electronics store... on the upside, they will probably be cheap, on the downside, re-soldering can be tricky.
I have a few similar ones that came out of a Saturn, the pins are pretty small, I'm wondering if they would work?
Mike
"The Constitution is not an instrument for the government to restrain the people, it is an instrument for the people to restrain the government - lest it come to dominate our lives and interests." - Patrick Henry
Bad laws are the worst sort of tyranny.
- Edmund Burke
relays are relays, I fixed my friends curse control unit in his VW by adding a external relay. since there was no room in the box for other then the factoy pos relay
Last edited by raccoon; 06-29-2014 at 04:30 PM.
1988 Lancer Shelby 2.2TII 1989 Shadow ES 2.5TI 1992 Lebaron Sedan 3.0Auto 1993 Acclaim 2.5TI-A520 Hoard parts now!
Best bet is to take a relay to a local electronic parts place and find a comparable one then.
I did a Google search on the part # Omron G5L-UA-006061. It came up with many matches. It didn't appear there were any that sold retail, but I only looked at the ones on the first page.
Barry
86 Shelby Lancer Prototype
90 Daytona Shelby VNT
91 Spirit R/T
For your questions about SDAC, please contact BadAssPerformance
Solder extension wires to the board then add an external relay holder.
Ian Adams Function>Form 1990 shadow scrapped, too rusty:( 1991 Spirit R/T Scrapped, parts sold:( 1989 Turbo Caravan Daily beater with built-[I]ish [/I]engine slowly evolving into weekend turbo beater.
I went to digikey's website this morning and I think I found a couple of replacement relays that will work. I will update this once I measure my bad relay and double check some other key things.
Think I found me some replacement relays. Going to order some up and try it. Pins all line up with the old one!
http://www.digikey.com/product-detai...1012-ND/280369
Nice! Good job...I don't know of anybody that has replaced anything on a BCM board before.