So I was running through my cal and I found a setting that may be off, but I'm not sure.

If you follow these tabs in MpTune

Idle > special setup > Constant Spark advance when setting mechanical basic timing

Mine is set to 6 degrees, and every cal I looked at is also set to 6 degrees. But in the table description it says that stock is 12 degrees. I'm curious if I need to bump that up to 12 degrees or just leave it alone.

Also in the same special setup tab there is the table "open loop enrich factor when setting basic timing"
Mine was set to 55 and the van always just billows black smoke. Is there any reason I can't just pull the enrichment factor down to the mid 20's, or even just to a zero reading?


Thanks
Joe