Soooo, the connectors that go to the power module on my 86 Shelby Charger are NASTY. They are rusty/deformed/etc. The car will randomly not start, you can't here the fuel pump run, but when you wiggle these connectors it will start up. I definitely want to make a solid repair before I start driving it on the road. My initial idea is to remove the power module, solder a wire on each pin, then fill the connector areas with caulk and install a better connector farther down the line. How is everybody else dealing with this issue?? Ideas please! L body parts are getting impossible to find, especially something so obscure as the connectors that go to the power module.