340+ hp 2.2 complete 2500 miles

[DieselRAM02]

Date: 17th June 2014
Username: DieselRAM02
Full Name:Bill Scarcelli
90 2.2. Balance shafts removed and blocked off, standard bore-mains-rods,crank scraper and windage tray,stock crank,K1 H beam rods, adjustable cam gear,new timing belt and tensioner,new water pump,braided coolant and oil lines for turbo,underdrive pulley,Wiesco forged pistons with file fit rings and spiral lock wristpins,rotating assembly balanced,new oil pump,clevite bearings,brass freeze plugs,Cometic mls head gasket,Steve Menagon head(Full port and polish,large stainless valves,chambers polished,new springs,seals,retainers,locks,followers,custom grind turbo cam)ARP studs for the mains and the head,ARP rod bolts,+40 injectors,Lonewolf Performance fuel rail,Accufab adjustable fuel pressure regulator,FWD Performance ported two piece intake with larger throttle body,Turbo Unleashed turbo header,Turbonetics T3/T4 Hybrid A/R .63 turbo,Turbonetics Evolution 38mm external wastegate,Turbos Unleashed Kevlar clutch and pressure plate with flywheel resufaced per clutch specs. Used Royal Purple Oil. 2500 miles on it. Dynoed a little over 340 Hp and Torque on 22 lbs of boost. Call Bill 267-250-3264 ASKING $3800. Possible delivery/carlisle.

[DieselRAM02]

Price is negotiable. Call with offers. Bill 267-250-3264

[ATaylorRacing]

That would be great in the 1880 lb Matchbox!

[moparzrule]

Who is the custom grind cam from? What are the specs?

[DieselRAM02]

Demos Cams lift I 411" E 450" duration@50 216/207 lobe separation 110

[moparzrule]

Is that a typo on the intake lift spec? .411''? Or should it be .471 or something?

Is this a billet cam or a regrind (requiring shims under the lifters)?

Also, are you willing to sell this cam separate?

[DieselRAM02]

Those are the specs on the sheet. The cams are ground from new. Contact Steve Menagon. That's who I bought the head and cam from. I want to sell engine complete ready to run.