CB crank gear and pulley and 11 mm ARP stud

[moe44688]

The motor is an 88 CB. Need the crank gear/pulley with all bolts. If anyone has ARP studs laying around I'll take them off your hands. PM prices shipped to 44688 with paypal email. I need pics for the crank pulley since hear there are several different styles

[jaysshelby]

do you know which one you need, square or round tooth?

[moe44688]

round tooth, sorry about that.
Just to clarify. I need a CB crank pulley from a 89-94 model year 2.2 or 2.5 5 bolt. I will need the 5 bolts as well and the center bolt. I also need the crank gear.
Thanks

[moe44688]

found a crank pulley.
Still need crank gear, 5 bolts for the pulley and the center bolt.
Also need a round tooth I shaft gear.
I'm surprised its so difficult to find these parts

[4 l-bodies]

Moe one of the problems is not everybody has the proper puller to remove crank gear from crankshaft. Then of course that is something not usually in your junkyard toolbox. I feel your pain, been looking for some parts myself for quite a while. I'll PM you.
Todd

[moe44688]

I remember trying to pull the gear off my crank on my t3. After hours with steering wheel pullers and torchs I took it to a shop who also gave up. So my buddy used a press I think, got the gear off but broke the aluminum piece behind it. In order to save the aluminum piece we sacrificed the gear this time around.

thanks todd

[4 l-bodies]

Moe, you need to clean out your PM box. Tried to send you a message but it was full.
Todd

[GLHNSLHT2]

so Todd an 88 2.2 TBI gear will be the same right??

[4 l-bodies]

so Todd an 88 2.2 TBI gear will be the same right??

Jay, Moe's 88 late casting date is actually a 89 model year, so what he is looking for is a standard round tooth CB crank gear. Not the 88 funky one that you used to make your masi crank gear.
Todd

[GLHNSLHT2]

Ahh, guess I should of read post #3.