I've made a few of these, but I wasn't planning on making any more.
However, I've gotten some emails about them so I'm starting a group buy!
If I can get 10 orders I'll make them.
So for now, just say "I will buy one" and I'll add you to the list.
Then when I get 10, I'll ask for payment, which will be $55 shipped to USA without any of the port holes, or $65 shipped to USA with the port holes. Shipping to Canada adds $20.
I figure since its a pretty simple part that I've made before, and its not too expensive, that we can just skip the whole deposit deal. haha
Heres the description of it:
This is meant to fit a 58mm throttle body.
It is 1" thick aluminum.
The bolt holes are 0.440" diameter.
The center bore is just over 59mm in diameter.
The outer profile matches the throttle body gasket profile very closely except for the added material for the NPT ports.
The top port is 1/4 NPT.
The three side ports are 1/8 NPT.