Where are the bands, thrust washers and bushings?
You need my modified rear sun shell, a bearing is added as it takes so much pounding it wears out the thrust washer and surface.
1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS!12.57@104 :O)
1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
2004 GSW TDI, 5 speed, fully loaded, modified.
Aurora ignition wires for sale. Link to info
Super60 roller cams or custom/billet cams. Link to info
This is all the kit comes with.
Got it for $150 shipped.
I will buy welded bands separate.
What are you looking to get for your modified version.
I'm saving this kit for later use to start I'll mix and match to get 4 and 5 fictions in that's all I'll need anyway.
Plan on the usual modifications and welding the case as shown in the transmission section. I just thought it was neat to actually find this kit and for so cheap at that.
That's not a bad price but there are better deals around, you can buy everything you need for $150. Sorry, didn't mean to come across like I did, lol.
I wouldn't use the transfer gear and diff cover gaskets, RTV works much better, buy the Mopar reusable pan gasket and add a drain plug. Either get the magnetic inline filter or add a proper external filter setup.
1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS!
1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
2004 GSW TDI, 5 speed, fully loaded, modified.
Aurora ignition wires for sale. Link to info
Super60 roller cams or custom/billet cams. Link to info
Where can you get both front And rear 6pk Kevlar clutch packs cheaper? Heck I can't even find them let alone cheaper. I am interested for sure because I looked for about 2 years before these came up for sale. Only other place I've seen is MRX and that charge $200 per 6pk.
Shoot me a PM on that sun shell if you don't mind. Any suggestions out tips are greatly appreciated. I've read through the all in one thread and links within so I know about the reusable gasket, adding the drain, the VB bleed mod, welding the case when pushing the 60ft times, and such but I've never even seen the inside of a ATX. Have a friend in Kentucky that's going to show me the ropes on the first rebuild. I'll be adding a Ed peters reworked obx LSD and a spacer from High Voltage fab unless I find one FS before then.
Posting Permissions
Reply With Quote