Hey guys I recently purchased a set of turbo coolant and oil lines and am having problems installing them, first off every line connection on the turbo end is wrong, very very aggravating since these are not cheap at all. anyways I'm trying to find a fitting to convert 8an to a 3/4-18 inverted flare, both sides need to be male and as short as possible.
I have searched high and low and cannot find this, I have started to accept the fact of I might have to go from 8an to NPT then NPT to 3/4-18, but I'm having troubles finding even a 3/4-18. Which is not what I wanna do but if I cannot find the right setup I am going to have to, anyone have any suggestions on this?
Now the fittings that came in the kit are all NPT which I have to remove the brass fittings in the turbo and I really don't want to break them off, since I know how that stuff goes, I tried swapping to a bigger sv and one bolt broke and I said screw it.