2 piece upper plenums

[lengel]

Plenum end caps

[lengel]

1/2 way done on the TB flanges!

[iTurbo]

Very nice. Great job Adam, I wish everyone put hard work and dedication into stuff they built like this. Where I work, I try as hard as I can to make the nicest tile shower enclosures I can, even though the owner doesn't seem to care one way or the other. It doesn't matter though, as long as you keep your own standards high and keep doing better all the time.

[Punish'nRice]

Looking good. Thanks for adding me to the group buy.

[lengel]

I got all the TB flanges done today, and cut all the plenums, so they are ready to start machining. Getting there!

[lengel]

Got all the plenum tubes done this past week. Today all the pieces were taken down to Brian's shop to get welded.

[Punish'nRice]

Got all the plenum tubes done this past week. Today all the pieces were taken down to Brian's shop to get welded.

Saweet!! shouldn't be long now.

[lengel]

Plenums are done! Picked them up from mr. Slowe's shop today, and he did a great job on them. Thanks Brian! I will be sending pms to everybody tonight or tomorrow.

Thanks Adam

[iTurbo]

Payment sent. Thanks Adam.

[j4278h]

If someone backs out of one, let me know.

[wheming]

Btw, now that we are so close to delivery, was there a thread on installation and what is required?
It sounded like my 52mm TB would be ok, but was there a need to change cables?
Planning now to use this on MeanMini.

[omni_840]

^^ Good idea Wayne

BTW Payment sent!

[lengel]

Btw, now that we are so close to delivery, was there a thread on installation and what is required?
It sounded like my 52mm TB would be ok, but was there a need to change cables?
Planning now to use this on MeanMini.

^^ Good idea Wayne

BTW Payment sent!

I personally never installed one, but the only things I can think of that will have to be done is sensor/vacuum holes drilled and tapped, run your intercooler piping over to the new TB location, maybe lengthen AIS and TPS wires. I dont know about the throttle cable. I wouldnt see why it couldnt just be lopped around. It should be long enough since the TB is closer to the fire wall.

Adam

- - - Updated - - -

I will be shipping all the plenums after work for the people that are paid in full. I will be sending everybody a pm tonight with tracking info.

Thanks Adam

[lengel]

Paid plenums have been shipped, and tracking #s have been sent.

Adam

[nvysion]

Money sent

[wheming]

Got mine! :thumbup:

[tthcare]

Thanks Adam
Received mine today.
I would not hesitate to buy something from you again. I waited a longtime for a part that had to be manufactured from a vendor. You were true to your word on timing.

[krut]

Thanks for doing this group buy! Keep us posted on anything else that may be made!
Thanks.

[iTurbo]

Got mine today, thanks Adam!

[lengel]

Thanks for the positive feed back guys!