I ordered the bushings a while ago, and am just getting around to installing them. I apparently lost the instructions when I moved, and they aren't up on your site. I need to know which bushing the "long" and "short" sleeves go into.
I ordered the bushings a while ago, and am just getting around to installing them. I apparently lost the instructions when I moved, and they aren't up on your site. I need to know which bushing the "long" and "short" sleeves go into.
Ok finally found the instructions on the website. No mention of short vs long. Ended up checking out the remains of the factory bushings and figured out the larger bushing on the rear gets the short piece and the front gets the long piece.
Yes short sleeve on the rear of the a-arm, long sleeve on the front of a-arm.
Look on page two of the instructions, bottom of the page, red letters.
---------- Post added at 05:32 AM ---------- Previous post was at 05:32 AM ----------
Sorry, just saw this question, you could have emailed me direct or called.
Great stuff for great cars! Poly engine mounts and bushings at: http://www.polybushings.com
One thing is make sure the sleeves sit in a bit, when I did mine, I shortened them a tad so there was some side preload on the bushings.
1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS!12.57@104 :O)
1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
2004 GSW TDI, 5 speed, fully loaded, modified.
Aurora ignition wires for sale. Link to info
Super60 roller cams or custom/billet cams. Link to info
+1 I did the same with mine.Originally Posted by turbovanmanČ
Posting Permissions
Reply With Quote