This is on my Horizon. I have a good inch of plunge on the left side cv shaft and only about a half an inch on the right. The engine is all the way to the driver side as far as it will go. I loosened the k member mounts and tried to shift it over to see if that would help a bit but I didn't get much if any movement. Do I need to be concerned about this? Before I moved the engine all the way over I had to remove the a arm on passenger side to get cv shaft in and get the ball joint in the knuckle. I pulled the un-equal length setup out of a omni that was in the jy the shafts look like OE to me. I didn't think to compare the length of the new right side shaft to the old. any info appreciated.