Results 1 to 7 of 7

Thread: runs for 20 seconds then idles like crap and dies

Threaded View

  1. #1
    Supporting Member Turbo Mopar Contributor j4278h's Avatar
    Join Date
    Dec 2005
    Location
    michigan 49045
    Posts
    2,086

    runs for 1-2 min at 2200 rpm then dies

    The car is an 87 daytona shelby z. Car sat fine outside for 8 months and fired up soon as i tossed a battery in. Moved it into the garage for a week to get computer/injectors changed back to stock. Now the stupid car will run for 20 seconds then idle drops to almost zero and pops and sputters until it finally dies. If I keep my foot on the gas it will stay running but get the check engine light to flash and idle has a mind of its own. When it starts to act funny the asd relay in the power module clicks like crazy.

    Running good had +40 injectors/ fwd ecu/ 3 bar
    Poor running and dies stock injectors/ stock map/ and stock ecu.

    Changed out hep, pm, lm, coil, map from a good running car 10 feet away and still get the same issue.

    No codes

    UPDATE,

    car now runs at 2200-2500 rpm constantly, as soon as it gets warm to drop idle the car cuts out and dies. All power drops out, the dome light even goes out when the car dies. Unplugged ais no change, unplugged map sensor no change.
    Last edited by j4278h; 03-22-2013 at 03:43 PM.

Similar Threads

  1. runs good after start then dies out
    By Fox in forum "I need help!"
    Replies: 4
    Last Post: 03-23-2013, 03:15 PM
  2. 95 neon idles/runs like crap
    By 83rampage in forum Maintenance & General Tech
    Replies: 7
    Last Post: 09-30-2012, 08:04 PM
  3. Engine runs at idle, surges and then dies
    By clarkwhoracing in forum "I need help!"
    Replies: 9
    Last Post: 08-03-2011, 07:27 PM
  4. HELP Code 26 - starts, idles, dies.... about that quick.
    By gears351 in forum Electrical & Fuel System
    Replies: 6
    Last Post: 10-13-2010, 09:28 AM
  5. car runs for 10 seconds then stalls
    By turbospirites in forum "I need help!"
    Replies: 46
    Last Post: 02-28-2010, 11:41 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •