Date: 28th February 2013
Username: bill2
Full Name:Bill Obendorf
City, State, Zip: Tucson Az, 85755
Contact: Pm
Price: see below
I'm cleaning out the garage and don't think i'll be using these anytime soon. Prices don't include shipping, if your interested in pick-up it would be welcomed!
3" Turbo's unleashed swingvalve. Excellent condition, i added a couple c clips behind the puck so that it wouldn't stick and it worked perfectly. 225$
2 piece intake with fuel rail, and 46 mm throttle body. No injectors, wire harness or tb sensors. Intake is in good condition, has been re-"wrinkled" (not perfect but looks good). Fuel rail is in good shape, although at some point an accufab was installed without ALL the needed washers and it has some light damage to the cup. It isn't far down at all, i cleaned it up and never had a leak issue- just wanted to mention this. 215$
Glhs mopar performance lm(stage 2?), part number 5249670 100$ (center pic)
Socketed 87csx/daytona lm (no chip) 75$ (on left)
Unknown lm?, says 86 mt on it, has 5227369 on chip. I pulled this from a car I switched over to later elecronics, but i didn't write on it and don't remember what it came out of... 20$ (on right)
Vented valve cover with moroso catch can. This is a pretty cool setup, i picked up from another member but never ran. The valve cover is a one piece gasket design, and includes AN fittings and large steel braided line to the catch can. This is some serious valve cover venting! There is an AN fitting on the top that is capped but could provide additional venting if needed. 100$
944 intercooler. Great bar and plate intercooler. 50$