Looking for standard bore 2.5 cb or 2.2 t2 common block.
Looking for standard bore 2.5 cb or 2.2 t2 common block.
I moved to Wellsville, NY area and never changed my location but if anyone even in PA that lives relatively close let me know. I also can trade I have a 2001 2.4 missing alternator and intake manifold. The 2.4 needs a headgasket and I would prolly do timing belt and water pump and tensioner while your there.
Hey...I might have an engine for you. I am located in Buffalo so not too far away. I have an 88 2.2 that just has a crank and pistons in it. Cylinder walls may need some work. I have an 86 2.2 with an 89 top end bolted to it. It made some type of a slapping noise last time I ran it. Not sure if it was from the top or bottom end. The can seal can out and some oil came out. I stopped driving it before too much damage was done. Also have a complete 88 2.5l NA engine...ran fine. This might be the one you are most interested in, 87 2.2l fully assembled. Head gasket just replaced. I believe a seal is bad in the turbo as it puffed white smoke last it was driven. Lastly I have an 89 2.2l bottom end with +20 pistons for a hybrid setup. One piston needs replacement...about 200 miles on the build. Let me know if you are interested!
Looked up Wellsville. Pretty far away. I'm in NW New Jersey. I have a complete 2.5 TBI from a '91 Daytona I would gladly trade for the 2.4. I'll send you a PM.
Mike
Bump non common block is fine just need a t2 or tbi engine ASAP car produced a rod knock.