TPS voltage

[forcedfedmopar]

I was checking a few things the other night in the omni and noticed that the TPS voltage at WOT is only 3.9-4.0v. Im running an 89 stage 5 cal from FWD. Is this voltage high enough to actually trigger WOT map in the computer? Would there be any benifit from "clocking" the sensor for more voltage at WOT? I seem to remember other vehicles iv had in the past having 4.3v or greater?

Thanks

[roachjuice]

Throttle cable stretching out maybe?

[forcedfedmopar]

no i manually checked it too by operating the throttle linkage by hand at the throttle body.

[roachjuice]

Ah ok. Have you swapped tps sensors yet? Go grab one from a salvage car. I think the v6 cars were the same iirc.

[shackwrrr]

3.5 is enough to trigger WOT so you are good. Do you have a scan tool, there should be a reading for TPS %

[forcedfedmopar]

i cannot check inputs on the scanner. i just check them manually.