anti-rattle clips K-H single pin calipers

[RoadWarrior222]

i had the napa hardware kit which came with 2 sets for 1 axle... basicly double of everything to do 2 cars...

I did that the other year, bought a set of pads, calipers and a hardware kit and got stuff with the pads and the caliper, so ended up with 6 of some things still needed a piece or two out of the hardware kit though.

[Tony Fields]

Great idea to show the clips on the pad outside the caliper

Attachment 42099Attachment 42100Attachment 42101Attachment 42102Attachment 42103


ok so i figured it all out... i had the napa hardware kit which came with 2 sets for 1 axle... basicly double of everything to do 2 cars...

the out board pad can use up to 2 clips, the inboard pad also can use 2 clips... you will note on the inboard pad, where there is no clip pictured there is a notch at the bottom rit of the pad backinh plate... note the driection of the clip in the next picture... keep all the clips facing the rotor side...as far as i can guess, these also act as wear indicators....

theres only 1 on the caliper... it goes where the little tang goes under the bracket...
kinda tricky to figure it out but look at the pics and you can see exactly how it goes on...

so after hours of searching, Tonys pictures and this thread, we now have a definitive diagram on how these little clips go....

[Dez]

Would this be about the same for a J-body?

[22shelby]

if it has the single pin caliper then yes...