Okay well we got most the wiring sorted out and itll start up and idle, but it isnt spot on, getting some black smoke when on throttle in neutral. I connect the scanner and its def. not right, I have 5.00v and knock sensor, map volts are all over, it shows no rpm's...werid cause itll start right up.....basically its wired so when the key is on the power is sent to all power feeds(is this okay?)..we have good grounds, or so it appears right now. Have a stock T2 manual smec in it right now with 2bar map. Any thoughts on the subject? Thanks in advance. BTW I tried and different smec same issues. Gonna check all the major sensor runs in morning.
---------- Post added at 06:07 PM ---------- Previous post was at 06:05 PM ----------
Forgot the dang codes at home.....