Ok so i may have scored a set of 0z racing p-1's. Their gunmetal gray and look kickass. the good...... The offset,bolt pattern,and size are very good. Their 17x7. the bad. The centers of the wheels are too small. Not by alot by any means. Question is is it safe to sand down/shave a tiny bit of material on the wheels/bearing area on the hub to allow them to slide over? I could take off the hub or whatever and take it to a machine shop to have it lathed off so it would be perfect. Keep in mind ill most likely be getting these extremely cheap or free so i can do some work to get them to go.