I have a turbo 2 car n trying to figure out how to tell which wire is which on the o2 sensor cuz i need to kno which one is the signal wire for my air fuel ratio gauge. thanks
I have a turbo 2 car n trying to figure out how to tell which wire is which on the o2 sensor cuz i need to kno which one is the signal wire for my air fuel ratio gauge. thanks
3 wire or 4 there are a ground power ans signal one. ckeck for ground on one then check for voltage on other two with key on
Its a 3 wire. two blacks and a white. I dont wanna sound dumb but how do i.do that?
well ground will showw with just a test light to pos side of battery then check which one light the light, the 12 volts will have on ned side of battery then turn key on the rff. wire will be the onthat does not light the light. hope that helps
What year car?
Usually the white wire will be the signal as the 2 same colours are for the heater. If the white wire is the signal, it will have 0-1 volts.
1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS! 12.57@104 :O)
1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
2004 GSW TDI, 5 speed, fully loaded, modified.
Aurora ignition wires for sale. Link to info
Super60 roller cams or custom/billet cams. Link to info
88 dodge lancer shelby. so the one i have to splice ito is the white. What do u mean by heater?
Last edited by lbaonocsetr; 08-26-2012 at 07:43 PM.
1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS! 12.57@104 :O)
1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
2004 GSW TDI, 5 speed, fully loaded, modified.
Aurora ignition wires for sale. Link to info
Super60 roller cams or custom/billet cams. Link to info
right. i have to make sure i tap into after the plug cuz if i ever have ta replace the o2 sensor i wood be screwed. ok ill tap into the white one n leave the black wires go. thank u very much