I have a rebuilt A568 (w/3.50:1 FD) and OBX LSD that I just installed in my Spirit R/T. When I recieved the OBX from eBay, I checked to see if the axles fit inside and there were no problems; the axles slid right into the splines no problem.
Now I have the trans installed and I'm trying to get the axles in but they WON'T fit! The splines start to go in but they will not slide all the way in and it has about 1" to go before it's fully engaged. I've tried two different intermediate shafts with the same results.
I am seriously pissed off and feel like I wasted $450 on this POS! What the hell do I do now? The only thing I can think of is the rebuilder installed a different OBX than the one I sent and this OBX isn't machined as well as the one I had.