2 part question,
1st part
I am looking for new hardware because I bought the car without.
I need pressure plate bolts, flywheel bolts and if there is a ring/spacer for an 8 bolt flywheel.
My application is a 91 568 bolted to a 90 common block 2.5 I am bolting up a TU purple PP, 6puck plate combo to it, I did not see any such hardware offered on the site TU site, but if you guys can point in the right direction that would be great.
2nd part
If I was to rebuild my 568 is there a kit available for purchase that is recommended and or any upgrades that I should have while rebuilding it? Aprox mileage is 175K with unknown knowledge of rebuild prior to buying. I never drove it but was told the PO drove it around until issues with 16v motor. What are the weak points if any in the 568's?
Thanks guys