I just brought home an '84 Rampage today, and like most of them I've seen there is plenty of rust in the driver's side floorpan. I previously had an '80 024 that was very similar in the floorpan rust department. With this Rampage, I'm trying to visualize a good way to make some subframe connectors, which would weld to the front subframe mounting points, and tie in to a cross-piece which would be attached to the front of the rear-spring mounts.
Eventually, there will be a roll cage installed, but I'd like to have a good solid base to attach the cage to.
I'm sure there are people who have done this kind of chassis reinforcement on a Rampage before. Any advice would be appreciated.
Thanks,
Steve M.