Well, a hydro clutch probably wouldn't be hard to fab on a 543.
Well, a hydro clutch probably wouldn't be hard to fab on a 543.
Here is a good thread on Club3G: http://www.club3g.com/forum/3g-eclip...c-avenger.html
Pictures taken from above thread:
I never really got far enough to figure out if the caravan T-case would fit in the front, but i DID figure out that you can use a 2g gsx rear suspension/diff and get the gearing close enough to an awd 604 that you could run the awd with slightly staggered tire sizes. Now the caravan t-case has been adapted to the 543, so i havent run those numbers but i still think it is probalby workable if you use a 3.5fd 543.
Just throwing this out there.. if i were you id do an eclipse center console conversion. I like it much better than the avenger/sebring one.
I hope you go for it. I really liked my Avenger. I was JUST about to put it on coilovers/agx's and start adding power when i lost it.
Dont push the red button.You hear me?
If I were to use the Caravan AWD in one of these cars, I'd use the 2001+ AWD setup that has no viscous coupler.
I think not having a viscous coupler might be making more work since the coupler gives you a tiny amount of fudge factor which may allow you to use the almost-bolt-in gsx rear setup.
Dont push the red button.You hear me?
does the rear end of a dsm bolt up.. just need a custom driveshaft?
I think it bolts in with minor custom work
Why not just get a car or mini van with NO rot and use that? Why does it have to be newer?
Great stuff for great cars! Poly engine mounts and bushings at: http://www.polybushings.com
i think because he said hes sick of k cars.. had them to long?
Then something really different...510 Datsun?.....what about make a mid engine car, put the engine in the back of something.
Oh, FWD...Fiat 128.
Great stuff for great cars! Poly engine mounts and bushings at: http://www.polybushings.com
Something different. I have been yearning to drive something a generation or two newer. I suppose this forum may not the be the appropriate place to discuss replacing a turbo dodge but I think a DSM with a 3.0 is still relevant to the forum.
I want something with a tilt and slide sunroof = no TD
I want something with four-wheel independent suspension = no TD
Aerodynamic = No TD
Something without that stupid parking brake hole = NO TD
...
you get the point I'm sure.
lol i think he wants it to be fun yet replace all the jobs of his spirit... I.E. being somewhat reliable
My turbo dodge has this.I want something with a tilt and slide sunroof = no TD
My TD doesnt have thisSomething without that stupid parking brake hole = NO TD
Great stuff for great cars! Poly engine mounts and bushings at: http://www.polybushings.com
Build your own car. Something like a homemade Ariel Atom.
Great stuff for great cars! Poly engine mounts and bushings at: http://www.polybushings.com
1990 Mini Van
Great stuff for great cars! Poly engine mounts and bushings at: http://www.polybushings.com
Yes, in my black ES....
Great stuff for great cars! Poly engine mounts and bushings at: http://www.polybushings.com