QA1 adjustable rear shock install on GJKHPA body cars.

[Shadowv4l]

was just looking at this

89 Daytona Front:

Body Length:13.5"

2G Neon Front:

Body Length:13.750"

---------- Post added at 09:27 PM ---------- Previous post was at 09:26 PM ----------

but i guess if the difference is only 1/4" then it really shouldnt matter if I wanted to go 1" lower. just wanted to make sure.

---------- Post added at 09:28 PM ---------- Previous post was at 09:27 PM ----------

then again im assuming a P body has the same length as a daytona

[iTurbo]

Yes as far as the fronts, the BC Coilover package that Rich has developed uses SRT4 coilovers with custom upper camber plates to adapt the upper mounts. There is a spacer used to adapt to our knuckles ('91+ style) P-body uses same struts as Daytona....no worries.

[Vigo]

Personal experience has shown me that bolting a 2g neon strut and spring into a k-based car lowers it.

[rbryant]

The BC SRT4 fronts will lower the car slightly but how much really depends on the spring rate, the weight of the car, and how high you adjust them.

Using the stock style Neon strut/spring/hat will probably lower the Kcar because the spring hats are totally different and there is a lot of height added by the Kcar spring hat. The Coilover setup is really a different animal with more variables.

-Rich

[ShelGame]

Post #1 of this thread should really go in the KC...