Well I got one and it has 8 lines comming out of it(see pic)
the factory drum I was going to use has 6 lines(see any probs)
I would like to know if I can just plug 2 of the lines off(which ones?) and then I also need to know where the rest of the outlets are meant to go(as in front or rear and driver/pass sides)
I labeled the pic so I could get help w/ exactly which outlets go where
Thanks in advance
Matt
Last edited by Speedeuphoria; 10-15-2006 at 12:45 PM.
You're using 4 wheel disc pro valve for a rear drum car?
no, no, no
I swaped a coplete R/T rear trailing arm w/ 11" vented brakes
So from what I've found(can't search for ABS) the 4 lines comming out the bottom are all inlets, Can I just plug 2
or should I get a rusted prop valve so I can break the fittings off again when I try to losen them?
Last edited by Speedeuphoria; 07-18-2006 at 07:27 PM.
WHy not just find a valve for a non-abs car?
Posting Permissions
Reply With Quote