I took my OBX apart and like an idiot failed to keep track of things.
Which center hub gear goes in first the thick one or the thin one or does it matter?
I also had a dowl pin fall out (a big part of why I lost track of things) Is this a special bonus OBX part designed to break things? It didn't seem like it belonged in there and I haven't heard anyone mention it.
The pin is about half an inch long and about the same diameter as the bolts that hold the OBX together.
My washers were stacked as suggested on the list and uncracked. I did notice one particular piece of bad machining.
Hopefully it is ok:
I guess it is slightly blurred but you get the idea
BTW I measured the washers and they are:
1.1" outer diameter (27.94mm) I think up to 1.115 will fit.
.49" center hole (12.446mm) not that this really matters
.05 thick (1.27mm)
.085 height (2.16mm)
These look like good replacements
McMaster part number 96445K278
Precision Metric Belleville Disc Spring Chrome Vanadium,
DIN 2, 14.2mm Id, 28mm Od, 1.5mm Thk, Packs of 12
$5.92 Pack
OR
McMaster part number 96445K273
Precision Metric Belleville Disc Spring High-Carbon Steel,
DIN 1, 14.2mm Id, 28mm Od, 1mm Thk, Packs of 12
$5.29 Pack
One is a bit Thinner, the Other thicker...
Thanks,
Rich