I'm using LM V12.5. Which table do I adjust to lean out on deceleration? When I am on the off ramp, cruising to a stop while in gear, the a/r is usually 11-12. How do I adjust it to 16-17?
Thanks.
I'm using LM V12.5. Which table do I adjust to lean out on deceleration? When I am on the off ramp, cruising to a stop while in gear, the a/r is usually 11-12. How do I adjust it to 16-17?
Thanks.
I shut off all the fuel above idle vacuum in the fuel no throttle table.
Where is the fuel no throttle table found? I don't seem to find it. I am using the LM V12.5
http://www.thelostartof.net/tryingbe...nothrottle.jpg
Last edited by tryingbe; 06-03-2011 at 12:56 AM.
click on the dot that says Name (where it says groups/name/Type) and then scroll down. It isnt in the fuel section since its not normally used.
Ian Adams Function>Form 1990 shadow scrapped, too rusty:( 1991 Spirit R/T Scrapped, parts sold:( 1989 Turbo Caravan Daily beater with built-[I]ish [/I]engine slowly evolving into weekend turbo beater.
Ill check when I get home. I looked in V10 and it was there, unless rob changed the name of it for some reason?
Ian Adams Function>Form 1990 shadow scrapped, too rusty:( 1991 Spirit R/T Scrapped, parts sold:( 1989 Turbo Caravan Daily beater with built-[I]ish [/I]engine slowly evolving into weekend turbo beater.
I don't know where it is, I am still using Rob's old T1 based cals. It's right next to the fuelpartthrottle and fuelfullthrottle tables in those cals.
I don't understand. You posted a picture of FuelBaselineFromMap and that is the one you want to adjust to shut the fuel off in decel.
I have my fuel adjusted so it shuts off on decel but I'm using a SMEC. Swing by the shop or when you return my tools and I can show you how mine's adjusted.
A.J.
oh yes, fuelbaseline from map is the same as the old Fuelnothrottle table.