New product from "Top Fuel" Bender Fabrications
Billet Adjustable Throw Shifter Arms 523/568
Adjustable Ratio "arm" that replaces the factory arm on the 523/568 trans
Depending on where you place the bolt you can have 100% (factory setting)
85% 75% 65% or 55% of the factory throw (only forward/back throw, doesn't effect crossover selector)
Why be stuck with one setting on a short throw shifter
Daily drive it at 75%, one bolt change will put you 55% for drag racing
Give the car to wife or make a long road trip , put it back 100%
Autocrossing , adjust it 65% or whatever feels comfortable
(Testers say the 75% feels close to the Hurst neon short throw shifter)
All that is needed to install :
Gain access to shifter on trans (remove airbox , I/C lines ect...)
Remove factory shift cable at trans
Tap out factory roll pin
replace arm / re-install roll pin
Place supplied bolt through cable and into desired position
that's it
I'll be making a batch in a few weeks, now that the on road testing was a success
The 1st batch will $40 shipped , if everything goes well and people want more, then I *MAY* do another batch if there's enough interest
Here's pics of the prototype (shown with heim joint can be used but made to work with stock cable)
Some basic cosmetic changes have been made
Please LMK if your seriously interested in having one of these
thanks