One Piston for an 86 GLH-T

[zin]

Had a wrist pin go on the OE engine from the Omni, thought it might have been a rod bearing, but oil pressure never got worse and the noise was load dependent...

Anyway, if I can get a piston/rod assembly I might be able to make it good again, at least as a temp replacement for a truly dead 2.2...

Let me know what you've got and what you'd like for it, I prefer something that hasn't be used as a rattle or otherwise abused...

Thanks!

Mike

[5sp. mini]

i,ve got a 85 ti block just setting here. 20.00 + shiping. lmk can try to ship out monday alan

[zin]

Sounds good to me. PM me when you know the total and your PayPal.

Mike

[5sp. mini]

i will pull it sunday then pm you

[4 l-bodies]

Am I missing something here or what? Mike has 86 turbo swirl head piston with LW rod, and your gonna put 1) 85 G-head and HD rod in place of?
Todd

[Pat]

Hey Mike...I have a set of '87 T1 rod/piston assemblies (swirl, LW rod, pressed pin pistons). Very little wear, motor ran great, rod bearings that came off looked near perfect. I'd prefer to keep them as a set since three do me no good. Take the set for $45 shipped to CA and you can pick the one you want and have a few spares.

Pat

[zin]

Am I missing something here or what? Mike has 86 turbo swirl head piston with LW rod, and your gonna put 1) 85 G-head and HD rod in place of?
Todd

YIKES! That's something I didn't catch! I do need the swirl style assembly!

Pat, I guess it's up to you!

Mike