Results 1 to 5 of 5

Thread: Naviagor goes blank and resets when opening door

  1. #1
    Hybrid booster
    Join Date
    Nov 2008
    Location
    South West Washington State
    Posts
    965

    Naviagor goes blank and resets when opening door

    Ok, So going through all the bugs on a 88 Shelby Z I just picked up. Put a two button traveler in it. Display goes out and it resets anytime you open the door, shut the door it comes on. Someone hacked up the stereo wiring really bad, could this have caused it? The aftermaket stereo seems to reste too, som I am guessing the two are related.

    Any advice on where to start? Or would it just be easier to swap in a new dash harness?

  2. #2
    Super Moderator Turbo Mopar Staff 135sohc's Avatar
    Join Date
    Aug 2008
    Location
    SoMd
    Posts
    6,179

    Re: Naviagor goes blank and resets when opening door

    Look for a broken wire at the door to body span (inside that rubber boot) that could be making an intermittent connection. Or even the dome light switch at the hinge pillar and something not right with it. I dont know how a Daytona is layed out but bad grounds or other broken connections can cause some funky things to happen.
    1994 Shadow Sedan. 2.2 N/A, A568 400,000 miles. "the science experiment"
    1987 Shelby CSX #418. Long term rebuild and restore ?

  3. #3
    Hybrid booster
    Join Date
    Nov 2008
    Location
    South West Washington State
    Posts
    965

    Re: Naviagor goes blank and resets when opening door

    It happens when you open either door, and if you push either door lamp switch int he jamb it comes back on, so something is tied into the door lamp circuit? I am so lousy at electrical.

  4. #4
    Hybrid booster
    Join Date
    Nov 2008
    Location
    South West Washington State
    Posts
    965

    Re: Naviagor goes blank and resets when opening door

    Any other thoughts at this?

  5. #5
    turbo addict
    Join Date
    Feb 2010
    Location
    Piedmont, Ohio
    Posts
    4,109

    Re: Naviagor goes blank and resets when opening door

    The door switches provide a ground. I am guessing that the PO must have hooked up something wrong and it grounds out when you open the door. Im not familiar with the daytonas but do they have the picture of a car that tells when doors are open and whatnot? If so then the wiring could be mixed up there.


    Look for the tan wire going to the round plug on the back of the visual messege center.

    Ian Adams Function>Form 1990 shadow scrapped, too rusty:( 1991 Spirit R/T Scrapped, parts sold:( 1989 Turbo Caravan Daily beater with built-[I]ish [/I]​engine slowly evolving into weekend turbo beater.

Similar Threads

  1. Blank Display!
    By moparfwdsleeper in forum Electrical & Fuel System
    Replies: 2
    Last Post: 04-26-2009, 05:50 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •