Need some good axles for my a568 tranny.
Need some good axles for my a568 tranny.
Speaking of this, will the larger car inner joints fit on the Omni shafts(any year)?
Sorry to semi hijack your thread Mike. Thought the 2 were closely related.
Last edited by black86glhs; 02-05-2011 at 10:35 PM.
Bryan
86 GLHS #161, 2016 Impala
SDAC National Member, SDAC Buckeye Chapter Member
A man has got to know his limitations.....
For the 568 swap into an Omni there's a couple different way to do this. Here's what I did on my dads TII/568 GLHT, and it works perfect, and you can keep the equal length setup:
Drivers side: I'm using a stock '90 Omni automatic CV shaft, it bolts right in.
Pass side: I'm using the stock GLHT intermediate shaft and CV shaft, but I used the yoke from the 568 donor car. Basically, all you need is that yoke from your donor car(the short piece, about 8-10" long that goes into the pass side of the trans). Then you can just take it apart at the u-joint, and put that yoke on your stock shaft and you're good to go!
Here's a pict. The piece on the left side of the red line is from your donor car, EVERYTHING on the right side is your stock stuff. Just pull it apart at the u-joint, take your old 525 yoke off, put the new 568 yoke on, and put it back in. I would replace the u-joint also, as long as you've got it apart...
Mark
Sorry, can't have mine mike.