I'm doing the big brake setup on my Rampage using Spirit R/T rear discs, 24mm M/C, R/T prop valve, etc.
The bottom lines coming off the front prop valve on the Rampage go to the front brakes.
The bottom lines coming off the front prop valve on the Spirit R/T go to the front brakes.
I'm running into the issue of the brake line fittings on the rampage and using the Spirit R/T prop valve. They both use large and small fittings, problem is its reversed 180 degrees. Attached is a pic showing the two.
Anyone see any issues on rotating the Spirit R/T prop valve 180 degress so the fitting on the Rampage line up???