TI-TII and TIII stuff for sale, bit of everything!

[moparman76_69]

Using a swirl head at 44cc's, some say 50cc's?, .051" thickness gasket, comes out to 13.8:1, using 50cc's nets 11.8:1 and of course, using a .074 cometic it drops to 12.2 and 11.1:1.

um that might be a little to high for me, I'll have to cc my head first.

[turbovanman²]

Debating it on my e85 ride. Turbo and high CR would be wonderful. My Ghead is shaved down a good bit, so much that the timing belt is loose. I am worried that the valves may hit. What app were these pistons made for?

Well there for a 2.5, so I would assume a high comp race motor. The valve reliefs look to be in the right spot and they are pretty deep. I'll go measure them and post up the depth.

[turbovanman²]

The valve reliefs are in the right spot and are around .115" deep, stock turbo pistons, .084"

[moparman76_69]

So with those they won't sit down in the deck at all will they?

[move.58]

All for those JE 2.5 .20's unless that is my local deals works out

[turbovanman²]

So with those they won't sit down in the deck at all will they?

I would say no, but I'll compare one to my old JE's.

All for those JE 2.5 .20's unless that is my local deals works out

Sure, if Kevin bails.

[turbovanman²]

List updated.

[turbovanman²]

Updated again, Pistons sold.

[capt.juanloco]

i need several parts...maybe lying on a shelf. Have a 94' 3.0 sohc 12v needing adjustable cam gears, 1.6 rolling rockers. Am going to modify used set camgears, hopefully have enough pollack engenuity to make set of adjustables. Sure make my job easy if you had some or no anyone who might. thanx

[turbovanman²]

i need several parts...maybe lying on a shelf. Have a 94' 3.0 sohc 12v needing adjustable cam gears, 1.6 rolling rockers. Am going to modify used set camgears, hopefully have enough pollack engenuity to make set of adjustables. Sure make my job easy if you had some or no anyone who might. thanx

I might have some, I'll check.

[BarrySchrantz]

Do you still have the Wilwood Superlite Brake Calipers 120-3191?

[BarrySchrantz]

my reg. e-mail is barryschrantz@msn.com

[turbovanman²]

Calipers are sold, locally, sorry. Need to update.

[strmtrpr]

wat was the application for the comp cams adn valve springs for and do u have any uh uh performance coil overs for the front of a 94 shadow

[turbovanman²]

The comp cams springs are for a V8, I'll have to dig up the application.

Sorry, no coil overs.

[strmtrpr]

haha can i get just one set for a 2.5 app TEE HEE

[turbovanman²]

Yeah, I supply sets for our 4 cylinders,

[strmtrpr]

coolio i will definatley let u know when i need them when i start rebuilding my turbo motor