Well Ollie this is another fine mess you've gotten me in too...
I think that pretty much sums it up... I have a 89 Lebaron GTC that had a BAD tranny seal leak with CVs that had 169K - let's just say it was not only stinky but hummed quite nicely too.
I replaced the CV axles and seals on the tranny. Now, when I cruise down the road, I vibrate now instead of hum. I mean the whole damn car shakes! The shaking increases with speed and is very bad at 32-41 mph. I also replaced the sway bar bushings because they were pretty bad. So, does anyone know what the heck would cause this? I read in some other posts that it could be the motor mounts?? How can I check them? I had my honey get in the car and shift it from drive to N to reverse and didn't see a bunch of movement but, I am not sure of the tolerances. Also, when I make a hard right turn I hear a metal on metal thunk. I thought this was the sway bar initially but it happened after I replaced the bushings for the sway bar.
Sometimes I think I'm my own worst enemy...
Any help is appreciated.
Thanks
Bill