Results 1 to 9 of 9

Thread: fueling Questions on T-SMEC

  1. #1
    turbo addict
    Join Date
    Sep 2008
    Location
    Salt Lake City UT
    Posts
    1,603

    fueling Questions on T-SMEC

    I was looking at trying to use the AFR lines to adjust fuel and i only see 3 that have the live show up. full and part throttle fuel and fuel baseline from map. What does the fuel baseline one do?? I know on some cals there is a Fuel no throttle table but i don't see one here, how can i adjust fuel at idle/ coasting down?

  2. #2
    Visit www.boostbutton.com... Turbo Mopar Contributor ShelGame's Avatar
    Join Date
    Dec 2005
    Location
    Whitmore Lake, Michigan, Unite
    Posts
    9,918

    Re: fueling Questions on T-SMEC

    Fuel baseline and fuel no throttle are the same thing. There's a fuel flow chart posted in the EFI section that will walk you thru how the main fuel tables are calculated and used.

    The AFR line only shows up on those 3 tables because those are the only 3 tables that have the AFR built into it.

    If you want to adjust the idle fuel, there are a few ways to do it.

    1) Reduce the PumpEff at low RPM. For some reason, Chrysler left the PumpEff at like 60+% even at idle. When, in reality, this is probably not very realistic. So, reduce the PumpEff in maybe 5% increments below 1200rpm and see if that helps.

    2) Reduce the baseline/no throttle fuel table near idle vacuum. If you have a different cam or cam timing than stock, it's likely that you're operating in a different part of this table than stock and are calculating a richer mixture.

    3) Spark scatter fuel - Chrysler actually uses spark scatter and subtle fuel changes to control the idle speed primarily. The AIS motor is actually a last resort. This is because fuel and spark changes are much more responsive than the AIS motor. But, the constant changing spark and fuel make it hard to tune. There's another thread here about turning them off for tuning purposes.

    4) Then, there is the adaptive fuel which also works at idle. You might need to adjust those kick values. You can also dis-able the adaptives for tuning purposes...
    https://db.tt/SV7ONZpQ
    Rob Lloyd
    '89 Daytona C/S

    2.5 T1 Auto
    13.24 @ 100.5mph
    NHRA #3728 AF/S

    boostbutton.com
    tuning wiki

  3. #3
    turbo addict
    Join Date
    Sep 2008
    Location
    Salt Lake City UT
    Posts
    1,603

    Re: fueling Questions on T-SMEC

    thanks!

  4. #4
    Buy my stuff!!!!!!!!!!! :O) Turbo Mopar Vendor turbovanmanČ's Avatar
    Join Date
    Dec 2005
    Location
    Abbotsford, BC
    Posts
    44,167

    Re: fueling Questions on T-SMEC

    Good info Rob.
    1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS! 12.57@104 :O)
    1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
    2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
    2004 GSW TDI, 5 speed, fully loaded, modified.

    Aurora ignition wires for sale. Link to info

    Super60 roller cams or custom/billet cams. Link to info

  5. #5
    Banned Turbo Mopar Contributor
    Join Date
    Dec 2005
    Location
    Windsor, Ont CANADA
    Posts
    3,805

    Re: fueling Questions on T-SMEC

    can u link to the flow fuel chart? i cant find it

    with the pumping efficiency

    if the car is too lean at idle , do i need 2 lower it??? having problems keeping the car running with the cal i have. i copied the fuel start up that was on the S60 cal and i was finally able to fire up and stay running, but as the car heated up it seemed like it slowly leaned out until the point it stalled itself out unless i stayed on the gas.

    just curious about this pump eff. its alot higher then the S60 cal right now so i am figuring i need to lower it to keep the car running? got 72pph injectors and a taft S3 cam

  6. #6
    Visit www.boostbutton.com... Turbo Mopar Contributor ShelGame's Avatar
    Join Date
    Dec 2005
    Location
    Whitmore Lake, Michigan, Unite
    Posts
    9,918

    Re: fueling Questions on T-SMEC

    The S60 cal used a very modified PumpEff table to scale for injectors. The values in that table do not compare at all to real-world pumping efficiencies. The fuel tables are basically stock T2 fuel tables. It's really kind of a hack way of doing a big-injector cal, but that's what they did. Driveability was obviously not a priority. You certainly should NOT copy individual tables out of that cal into a 'modern' cal. I included it in the templates mostly for reference. And, I know a lot of people still have good luck using it.

    Spark timing should be good to copy over, though.
    https://db.tt/SV7ONZpQ
    Rob Lloyd
    '89 Daytona C/S

    2.5 T1 Auto
    13.24 @ 100.5mph
    NHRA #3728 AF/S

    boostbutton.com
    tuning wiki

  7. #7
    Buy my stuff!!!!!!!!!!! :O) Turbo Mopar Vendor turbovanmanČ's Avatar
    Join Date
    Dec 2005
    Location
    Abbotsford, BC
    Posts
    44,167

    Re: fueling Questions on T-SMEC

    Quote Originally Posted by ShelGame View Post
    Spark timing should be good to copy over, though.
    Just becareful, its very aggressive and without race gas, it will knock.
    1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS! 12.57@104 :O)
    1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
    2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
    2004 GSW TDI, 5 speed, fully loaded, modified.

    Aurora ignition wires for sale. Link to info

    Super60 roller cams or custom/billet cams. Link to info

  8. #8
    Banned Turbo Mopar Contributor
    Join Date
    Dec 2005
    Location
    Windsor, Ont CANADA
    Posts
    3,805

    Re: fueling Questions on T-SMEC

    simon no knock with S60 cal n crappy old fuel 94 octane
    i even ran a more aggressive cal with no knock.....my 2.5 likes timing

  9. #9
    Buy my stuff!!!!!!!!!!! :O) Turbo Mopar Vendor turbovanmanČ's Avatar
    Join Date
    Dec 2005
    Location
    Abbotsford, BC
    Posts
    44,167

    Re: fueling Questions on T-SMEC

    Quote Originally Posted by Juggy View Post
    simon no knock with S60 cal n crappy old fuel 94 octane
    i even ran a more aggressive cal with no knock.....my 2.5 likes timing
    I ran the S60 on my old engine, rattled without race fuel.

    My old engine loved timing too, then it blew up,
    1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS! 12.57@104 :O)
    1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
    2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
    2004 GSW TDI, 5 speed, fully loaded, modified.

    Aurora ignition wires for sale. Link to info

    Super60 roller cams or custom/billet cams. Link to info

Similar Threads

  1. LM/PM to SMEC conversion w/o rewiring the car
    By A.J. in forum Electrical & Fuel System
    Replies: 34
    Last Post: 10-05-2017, 11:24 AM
  2. SMEC SCI connector questions
    By 1BADVAN in forum EFI Tuning
    Replies: 9
    Last Post: 08-18-2009, 11:25 PM
  3. SMEC flashing questions.
    By quantum in forum EFI Tuning
    Replies: 3
    Last Post: 11-13-2008, 09:54 AM
  4. Smec I.d??
    By WOP'R in forum Electrical & Fuel System
    Replies: 23
    Last Post: 07-25-2006, 09:12 PM
  5. SMEC Pinout Questions...for the experienced...is that you? :)
    By Subliminal in forum Electrical & Fuel System
    Replies: 6
    Last Post: 02-22-2006, 01:29 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •