i got a leak thats pissing me off i can get it to seal with rtv till it goes through a heat cycle
i think the problem is that the aluminum is moving to much from the heat and the steel isnt so it just sorta pops the rtv off
im thinking of 3 solutions yamabond the right stuff or hylomar
all three arent meant for a threaded plug and i think the only reason yamabond works so great for sealing cases is becuase the case halves expand at the same rate
the plug has a shoulder on it that the brass washer sits on but its not cutting it i tried thread sealant rtv teflon tape and probobly something else im getting ready to jb weld the ----ers shut and just spend 15 bucks to drain the trans