im looking to upgrade but i want to start over completely fresh, so im selling my MSII.
includes everything you need to run on a TD, and i had this on my car for several months, works great, car would start on the first try every time.
MSI v3 board
MSII daughter card
DIYautotune wire harness
J & B peak and hold injector board
lebaron wire harness with all factory ecu wiring removed, modified for use with MS including external regulator for alternator
JAW wideband controller and O2 sensor
this MS is configured with the following features;
sequential injecton
single coil ignition
dual hep pickup for use with stock turbo distributor
tach output for use with stock tach
idle stepper motor control
fan control
uses all stock sensors
fully assemble and was used on a running car, ran excellent- car would start on first try every time. MS is still programmed to run on a TD and will probably start and run right off the bat when plugged in.
price- 275.00 +shipping.
ok heres some pics of the wire harness and 2 vids of the wideband and the MSII in operation
thi shows all the relays. i completely removed all the stock relays, MS,fuel pump, injectors, ignition, fan, and starter relays. also you see the old style external regulator wired in. the relay pack and regulator mount over by the driver side shock tower.
where the harnesses go through the original boot.
most of the wires are labeled, and everything is fairly well organized and bundled up so its not a rats nest. everything is there- right down to the battery cables.
heres a vid of the wideband in the custom display i made
and one of the MSII up and running on the stim