Son's engine is almost back together. He wanted to swap intake mani's - had a 2-pc and he wanted to put the correct 1-pc on the car (had a ported, powder coated 1-pc sitting in a box)
So I pull the int and exh mani's and one exh mani stud broke. Not a big deal, I pulled the mani off, clamped onto the exposed stud, fired up the torch and... ran out of oxygen. Crap. So in my final attempt I broke it off flush.
I went through my "collection" of exh. manis and picked one that is FLAT on both surfaces. Cleaned everything up real well and installed the mani's without the one stud.
Will it leak?