window scrapers

[kcvrodder]

Want to buy a set of window scrapers for a 88 daytona WITH t-tops. I'm will ing to pay top dollar for them but they must be in good shape and for a t-top. Thanks

[J&H Ryan]

martin kohler, arizona parts

[prepared]

When the cars were converted to T-Tops, the factory piece simply had a notch cut out of the very rear edge. Very simple to do if you have your old T-Top piece and a good standard piece side by side.

IMO, no need to limit your search to T-Top only parts.

[x.Gen]

When the cars were converted to T-Tops, the factory piece simply had a notch cut out of the very rear edge.

unfortunately incorrect, in my experience. the non t-top scrapers are shorter and align slightly different, with the lack of framing on t-top doors. I got lucky and bought a decent t-top set after searching somewhat actively for years. unless you get lucky, not many choices on this one.

hard enough to find that even though I have them still sitting boxed, couldn't easily bring myself to sell them, and I'm someone who could use the cash for sure.

[prepared]

unfortunately incorrect.

yeah, ok

[rosie]

martin kohler, arizona parts

Martin you watching this thread? Could you pm me with your contact stuff again?

Unless someone else has it. Search feature is a little funky on my smart phone.

Rosie

[Chris W]

AZ Parts- 480-966-6683

[J&H Ryan]

unfortunately incorrect, in my experience. the non t-top scrapers are shorter and align slightly different, with the lack of framing on t-top doors. I got lucky and bought a decent t-top set after searching somewhat actively for years. unless you get lucky, not many choices on this one.

hard enough to find that even though I have them still sitting boxed, couldn't easily bring myself to sell them, and I'm someone who could use the cash for sure.

Could be a case of mixing up the part numbers, but the parts that Martin sent me that he said were non-t top fit my car perfectly, except I had to notch them. Details in the resto thread in my sig.

[iangoround]

I had pulled the scrapers out of a hard top 85 Laser to replace the ones in my 86 Turbo Z. They were too short, by about an inch and a half if I recall. I went aftermarket for way cheaper than NOS parts.

Info here: http://www.turbo-mopar.com/forums/sh...ad.php?t=33106

[JohnnyIroc]

yep t-top ones are about 1.5 inches longer, not a factory cut down piece at all...............
i have plenty of hardtop sets if you want measurements...