Ive had my engine mounts built for months and the motor hanging in there. Well, today I installed the axle shafts and im not so fond of the angle they sit at. The motor is tilted right up, as in the top of the engine is pushed as far away from the firewall as I could get it to make room for the turbo. I had read elsewhere that this is fine to stand it right up. Looking at the axles makes me worry a bit. They fit fine, but the boot on the drivers side is within a 1/4" of the k-frame and both axles are angled back very slightly (the tranny side of the axles is further toward the back of the car than the hub side of the axle). Is this going to be OK?? I am going to obviously fire it up and see how it runs, but that is still a couple weeks off. Im just wondering if anyone has actually done this before without vibration issues or wheel hop, etc.

......I really dont want to have to cut the firewall on an 89 CSX to make room for the dang turbo!