Offer's welcomed! I'd prefer to have the transmission, engine, and exhaust picked up as I don't have a truck(trans and engine) and not 100% sure how i'd go about shipping the exhaust(suppose if someone wanted I could remove the rear suspension, wrap it as one piece and ship it that way).
Head(Lotus).. Great condition, no cracks, steel plugs, valve train included - SOLD to TurboJerry(shipped 4/26/10)
TIII timing belt covers.. bottom and top. 1 broken tab(lower) and 1 damaged, but complete rab(upper)... Gave to DOHCRT
Link to broken/damaged tabs...
http://i581.photobucket.com/albums/s...e/PICT0036.jpg
FWDP 3" Exhaust.. Turbo back, Walker muffler and magnaflow cat. Will be cut for removal... $250(firm)
Short Block.. Ready to run, was rebuilt a few owners back, forged slugs(JE), balance shafts deleted, stock rods and crank, brass plugs, crank sprocket and pulley - SOLD to DOHCRT
TIII Water Pump Diverter & Washer.. SOLD to DOHCRT
Garrett turbo - TIII, worked when removed, no in and out play typical side to side and no damaged blades. Ready to run $200shipped
TIII Exhaust Manifold.. No known cracks, and not porting.. $100shipped
A/C Compressor.. Worked when removed a last summer. Gave to DOHCRT
A/C-Alternator Bracket.. Good to due the timing belt tensior relocation - Gave to DOHCRT
91 TIII SBEC.. Stock cal... I removed the elbow when I relocated it to the glove box. - SOLD to DOHCRT
Rocker Arm shafts and bolts/washers - Ready to use - Gave to DOHCRT
Camshafter Sprockets - Both intake and exhaust - SOLD to DOHCRT
TIII water box assembly - SOLD to DOHCRT
91 A568 Transmission.. No issues shifting, no whines or grinds. - $325(Pending to turbo_III)
Intake Manifold.. Not ported, comes with throttle body with sensors(new TPS) - SOLD to DOHCRT
Timing belt idler pulley and tensioner pulley - both are in ready to use condition - Gave to DOHCRT
FWDP TIII exhaust manifold stud kit.. SOLD to DOHCRT
TU SS Turbo Lines.. Oil feed and return, coolant feed and return a few thoudsand miles of use - Gave to DOHCRT
FWDP TIII Intake manifold bolt kit - SOLD to DOHCRT
Passenger side axle(91+) - Unequal length - $20
Drive side axle(91+) - $20
TIII Snorkel.. The metal bracket is gone - $55shipped OBO
TIII air box assembly, with K&N filter - Gave to DOHCRT
Vacuum Manifold Block.. McCarter IIRC, Black, 6port(4 on top, 1 on each side) I found 1 fitting to go with it. - SOLD to HESaves
03-04 SRT4 'Viper' Seats.. Passenger side is in good condition, Driver side bolster needs repaired - SOLD to DOHCRT
03-04 SRT4 radio/HVAC bezel.. $45shipped