This weekend my son spun a wheel bearing on the CSXT. It has '89 CS rear vented brakes.

As soon as the car 'felt funny' he pulled over and I went and rescued it.

However, the inner bearing race of the outer wheel bearing is already seized onto the spindle shaft. I'm gong to ATTEMPT to pull the race off without damaging the spindle, but I've seen this before and I no longer have access to a lathe to fix the spindle.



I'm not sure if I have a puller with small enough 'fingers' to grab the bearing race inside the hub. The only other thing I can think to do is pull the caliper so I can pull the entire spindle/hub assebly and TRY to somehow cut the inner race so it releases from the spindle.

Any advice?