What cylinder heads flow the best?
2.0 SOHC, DOHC
2.4 SOHC, DOHC
Dan Rose
What cylinder heads flow the best?
2.0 SOHC, DOHC
2.4 SOHC, DOHC
Dan Rose
In stock form or potential? I think they are all prettly much the same stock, maybe the following highest to lowest?
2.4L Turbo DOHC
2.4L Early N/A DOHC = 2.0L DOHC
2.0L SOHC Magnum ('01+ R/T)
2.0L SOHC
Slight differences in manifolds earlier to later and by body style as well.
JT
SDAC Director
SDAC-Chicago President
JOIN SDAC and your local Chapter TODAY! - SUPPORT the CLUB that supports YOUR HOBBY!
87 Shelby Z - 10.50@141.66mph
87 CSX #751 Clone - 12.88@102.88mph
www.badassperformance.com
Check out Turbo-Mopar Times!
Submit your 1/4 mile times HERE!!
Support SDAC! Join Today!
"I'm not some pro athlete with a bajillion dollars, I'm just an every man"
Note: The information and any images provided in this post are not for distribution outside this forum without the author's permission.
Well both stock and potential. Port and polish, bigger valves, etc.
Dan Rose
I think the 95-99 dohc had bigger exhaust valves than srt head.
JT
SDAC Director
SDAC-Chicago President
JOIN SDAC and your local Chapter TODAY! - SUPPORT the CLUB that supports YOUR HOBBY!
87 Shelby Z - 10.50@141.66mph
87 CSX #751 Clone - 12.88@102.88mph
www.badassperformance.com
Check out Turbo-Mopar Times!
Submit your 1/4 mile times HERE!!
Support SDAC! Join Today!
"I'm not some pro athlete with a bajillion dollars, I'm just an every man"
Note: The information and any images provided in this post are not for distribution outside this forum without the author's permission.
Cool
What about +1mm in the oval port?
JT
SDAC Director
SDAC-Chicago President
JOIN SDAC and your local Chapter TODAY! - SUPPORT the CLUB that supports YOUR HOBBY!
87 Shelby Z - 10.50@141.66mph
87 CSX #751 Clone - 12.88@102.88mph
www.badassperformance.com
Check out Turbo-Mopar Times!
Submit your 1/4 mile times HERE!!
Support SDAC! Join Today!
"I'm not some pro athlete with a bajillion dollars, I'm just an every man"
Note: The information and any images provided in this post are not for distribution outside this forum without the author's permission.
Yes, +1mm exhausts on the early heads are good too. As good as these heads flow on the exhaust side, the standard size ('95-'99) is usually more than plenty. But if you have the money for valves & seats, why not!