Hi!
Been messin' with mopars for three years now and I've accumilated a pile of stuff. But none of the stuff I need.
Goin to buy some parts from midnighttoker and I need a few bones. Up for trades too.
86 T1 Intake setup.
Comes with intake, rail (no injectors), turbo side housing (might have the actual turbo inlet), throttle body + silicone tube.
$15+ s/h?
86 G-Head. - pending
Turbo G head off a T1. Not bad shape 165k on it
$45 plus shipping
T1 Ported exhaust manifold + Ported garret housing ported out to 2.4"
Had these ported, and paint baked in hi temp black 1800+ degree
$100? plus shipping
Mallory Promaster Coil pn#29625
Great coils. I use them on everything. 67,000v! Good to 10,000 RPM. They run 6500RPM all day at 185F! Brass terminals, Spark plug secondary post.
$50 + shipping
Accel Supercoil
one of those big daddy accel coils.
$35+ shipping
Crane Cams HI-6 Ignition & LX92 coil
Complete box with unmolested wires. Run for less then 15 hours. Built in Rev limiter. Main gain with this box is multiple spark discharge for 20 degrees of rotation. more spark+more fuel being burnt+more boost= fun. I have two of them, if you want both I'll throw in a automatic coil selector.
$135+ shipping
Complete set of Sealed Power 8V 2.2L pistons - pending
Bought them from clayton. Never used. These DO have the clip rings for floating pin pistons. Part number is 533P.
$100
I got some hardcore lightweight racing seats, aluminum.
Few odds and ends for race cars, 5 point harnesses, wheels, tires just ask.
I'm really looking for...
decent common block 2.2
Two piece intake+w/ injectors and rail
8 Bolt flywheel
88 CSX front end
88 CSX parts in general. Emblems, steering wheel, body kit, seats etc
You can pick the stuff up or drop by to look
Tri-State Racing Equipment
4954 Bluebird Rd
Lebanon, TN
EDIT:
If you want pics say so and I'll get them.