ok having some problems.
went to make a 2.2L cal based on T-LM V10.
opened up the template, scaled map stuff, scaled injector stuff, loaded a comparison, moved some points to match, added some points here and there, manually went through every table and checked values and selected 3-bar selections (as it wont do it when scaling), selected config values, turned off cel masking for most known errors and then saved the template, overwriting the original.
then i went to compile and it asked me for the .asm and then the .v10 template, then calls up the assembler and then stops with a "major error" of this:
if i unzip T-LM V10 into a folder and only compile without making any changes, it works. as soon as i make a change to the template before compiling, it gives me an error. i remember when i made only 1 change to one single point in the peftbl the error line was 78 and not 79.
other issues:
limiting scaling injectors to 95 lb? E85 can easily exceed 120lb injector because of the flow rate needed. then again, i have to fake the scaling process so scaling for 120lb actually means scaling to 92.4 when scaling for e85. but for a gas application with a 16v head (or reeves) 95lb can be easily exceeded.
lots of temp values have no axes defined and i assume that is because they arent defined in the template?
also, rev limits dont seem to be handled correctly like in Chem2. reversing the axis values from 0-8192 to 8192-0 doesnt seem to be correct either.
there might be an error in the table name OverboostShutoffBa.wordastegate . it looks like some of the coding got copied into the name. dunno if that caused problems elsewhere.
i cannot yet get away from using 2-3 programs to make a cal.
its getting there though