Rob M
Spartanburg SC
Contact: PM or e-mail, or post in the thread E-mail is ForceFedMopar4me@aol.com
Payment: Paypal or money order, Paypal addy is also ForceFedMopar4me@aol.com
Tired of looking at this stuff, needs to go. Some prices are negotiable, none include shipping.
3 silver early Turbo valve covers, $10 each, or all 3 for $15
Chrome 2.2 HO/Shelby valve cover, complete w/ torquing rails, PCV box and oil baffle, $50
3 V6 starters, all good when pulled, $15 each, or all 3 for $30
Large Nippondenso 2.2 starter w/ support bracket, works $15
V6 alternator $10 (will fit the 2.2 by swapping the pulley)
3.0 V6 auto SMEC, from a '88 Caravan, rare computer $50
'84 Shelby Charger 2.2 HO Spark Control computer $15
'90 Omni 2.2 TBI auto SBEC II $25
'90 Lebaron 3.0 V6 auto SBEC I $15
'86 T1 Logic Module $25
'87 T1 Logic Module $50
Turbo cam w/ square tooth gear and seal, needs cleaning up $10
Cam/I-shaft gear, square tooth $5
Omni rear seatbelts, red $10
T1 log air cleaner bracket $5
2 4-bolt crank pulleys, w/ AC $5 each
T1 log fuel rail w/ injectors $20
Intermediate shaft, good shape $10
Early style A/C compressor mount bracket $5
5 46mm TB's, $5 each
4 52mm TB's, $10 each, or all 4 for $35
Chrysler-style alternator, off an '84 Shelby Charger, worked when removed $10
1st Gen Neon TB $10
Shifter boot, for '89-older cars $5
Center upright console for '85-up L-body w/ A/C, has the map light $15
Center upright console '85-up L-bodies w/o A/C, has heater vents $25
Cam gear set for 2.0/2.4 $10
'93 P-body 3.0 V6 5-spd engine bay harness, no cuts $75
'92 Lebaron auto center console $10
Loaded 782 turbo head (has valves) $50
Loaded 287 turbo head $35
CB 2.5 Turbo block, needs boring $50
Non-CB 2.2 T1 block, '86 build date, needs boring $25
2 8-bolt auto flywheels $5 each
525 trans from an '83 Rampage 2.2, needs shift fork pads and maybe an input shaft bearing (has slightly more than normal play in it), gears are all in excellent shape $50
2 non-CB oil pans $10 each
Hood vent drain pan from a Shelby Charger hood, very clean, no rust, complete piece, was removed by drilling the spot welds out, includes the plastic tray that attaches w/ plastic push-pins $25
2 Rear hub and spindle assemblies (includes bearings, dustcaps etc), fit both drum and disc brake cars $20 each or $30 for the pair
Holley feedback carb for 2.2, looks decent but never ran it, good for rebuilding $15