Chipped SMEC not working

[CSXRT4]

Ok ive chipped many SMECs in the past with no problems. I just chipped one for a project my dad and I finished, and this is the first time ive used a sst27sf512 chip. I erased the chip and then burned a fresh cal at an 8000 offset (32k bin file). When I put the chip in and turn the key on, all the injectors click on and stay on, and the fuel pump does not turn on. I tried burning at different offsets and the same thing every time. I dont think I messed anything up when I chipped it so I dunno if its a chip programming issue or the SMEC is shot. I dont have another SMEC to test with either

You guys think the SMEC is toast?

[bakes]

do you have another chip to try just to eliminate the smec?

[CSXRT4]

yeah I have 2 brand new sst27sf512 chips and it wont run on either of them

[butchsuppe]

I got a good one $60 shipped.

[turbovanman²]

The offset is wrong or its not loading properly, the clicking is the give away. What are you burning it with?

[cordes]

Make sure you have the chip oriented properly. You may also want to try another file. I had the worst time with chips at minigts' place a few months back. It ended up being a corrupted file.

[roachjuice]

Make sure you have the chip oriented properly. You may also want to try another file. I had the worst time with chips at minigts' place a few months back. It ended up being a corrupted file.

+1

[CSXRT4]

Turned out to be a bad SMEC, I must have damaged it when I chipped it.

This morning I decided I was tired of guessing so I went to the junkyard and picked up another SMEC ($50 ). Anyway I chipped it and everything is working great now. Thanks for all the ideas though

I will have to get some pictures up soon. You guys would probably like it, 16v hybrid engine into a sand rail.

[turbovanman²]

Turned out to be a bad SMEC, I must have damaged it when I chipped it.

This morning I decided I was tired of guessing so I went to the junkyard and picked up another SMEC ($50 ). Anyway I chipped it and everything is working great now. Thanks for all the ideas though

I will have to get some pictures up soon. You guys would probably like it, 16v hybrid engine into a sand rail.

Bummer and way cool,

[risen]

Turned out to be a bad SMEC, I must have damaged it when I chipped it.

This morning I decided I was tired of guessing so I went to the junkyard and picked up another SMEC ($50 ). Anyway I chipped it and everything is working great now. Thanks for all the ideas though

I will have to get some pictures up soon. You guys would probably like it, 16v hybrid engine into a sand rail.

So, do you have plans for that junk smec?